Tri-Clamp 1.5" Mounting Clamp

A quick clamp solution for any 1.5" Tri-Clamp connection. Use this clamp in place of a standard 1.5" Tri-Clamp to mount a fitting to your brew stand.

• Welded from SS304 components
• Footplate is 80 x 20 mm with 6.5 mm holes
• Height from bottom of footplate to the bottom of the Tri-Clamp is 19 mm.
• The height is adjustable approximately 2 mm
• Can be mounted on the front of your brew stand
• Quick removal of fittings by loosening the set screw
• Tri-Clamp can be rotated 360 degrees for optimum placement

The clamp is designed for table top support of fittings connected to a kettle ferrule with a height of 5cm at center (our standard bottom ferrule height). On our 4/2 HERMS - HLT kettles, the bottom ferrules for the HERMS coil are 1 cm higher than the standard ferrule height of 5cm. If you plan to use the clamp for a fitting attached to these ferrules on the HLT kettle, you will need to use 1 cm spacers between the clamp and the table top, when screwing the clamp to your table top.
 
Do not install the clamp upside down, i.e. to the underside of your brewing table. It is not designed to hold the weight of the fittings in that position!