Home / Tri Clamp / Fittings / Thermowell and Float Switch AdapterThermowell and Float Switch Adapter40,00 € incl. 19% VAT plus VersandA Combination fitting: Thermowell and float switch in 1.5″ Tri-Clamp form.Out of stock SKU: TFM01911 Category: FittingsZum Merkliste hinzufügenZum Merkliste hinzufügen Question about Product Description Additional information Reviews (0) Especially made for our RIMS tube but could also be used in a kettle port to prevent dry firing your element. The float switch is not capable of switching more than 0.5 amps and must be used with a separate relay to control your heating element or pump.Because the return of the RIMS tube is most often underneath the wort level in the mash tun, water will not drain from the circuit when the pump is stopped. This would normally prevent a float switch from operating properly. To fix this we have added a small washer as counterweight that provides just enough weight to push the float down when flow is reduced to approximately 1 l/min.Thermowell: 6cm long, 7mm ID, with cable gland Holder for 6mm cable sensorFloat switch:Voltage 0-220Vswitching current 0.5ATemperature resistance 200CStainless bodyThe float contains magnetic materialScrews into the Tri Clamp endcap with a silicone gasket and stainless steel nut.Can be used as an NC or NO switch.Weight0.16 kgDimensions9 × 9 × 5 cm ReviewsThere are no reviews yet.Only logged in customers who have purchased this product may leave a review.