Tri Clamp Lid Bulkhead Fitting
20,00 €
incl. VAT plus Shipping
Triclamp 1.5″ bulkhead fitting with 6 degree offset angle.
Lieferzeit: 3-5 Workdays*
In stock
A Tri Clamp 1.5″ Bulkhead with 6 degree offset angle to screw into our kettle lids.
Can be used as an adapter for the steam condenser or hop port. Requires a 42mm hole. Includes a 1.25″ stainless lockring, a 38mm ID Silicone Gasket with lip, and 1.25″ stainless steel washer. The gasket and washer are used to protect the lid from being scratched, and are not strictly required. Note: the fitting is not water tight and must be used above the wort level.
Just to be clear: our lids have an approximately 6 degree slope. If this fitting is used with a flat lid, it will be slanted at a 6 degree angle. Note: the fitting is not water tight and must be used above the wort level.
To install, place the gasket over the threads and insert fitting into hole in the lid. Rotate until it is level. Place the washer and then tighten the lock nut.
If you would like us to drill the hole in your lid for you, please add this product to your order: Lid hole for Tri-Clamp bulkhead fitting
Weight | 0,14 kg |
---|---|
Dimensions | 4,5 × 5 × 5 cm |
Only logged in customers who have purchased this product may leave a review.
You may also like…
-
Hole Punch 41 mm
5.00 out of 518,00 €incl. VAT
plus Shipping
Lieferzeit: 3-5 Workdays*
Add to cart -
Lid hole for Tri-Clamp bulkhead fitting
0 out of 515,00 €incl. VAT
plus Shipping
Lieferzeit: 3-5 Workdays*
Add to cart
Reviews
There are no reviews yet.